DEN FYSISKE BUTIKKEN ER ÅBEN ALLE HVERDAGE 10:00-17:30 OG LØRDAGE 10:00-14:00 - SE ALLE ÅBNINGSTIDERNE NEDERST PÅ SIDEN
Insulinpumper og vand er en dårlig kombination.
Dette beskyttelses etui vil lade dig bade, tage brusebad eller padle med ro i sindet.
Nøglefunktioner
Hvor vandtæt er det?
Vandtæthedsniveau = IPX6
Dette etui er udstyret med vores 'TC' Aquaclip, der gør sagen vandtæt til IPX6. Midlertidig nedsænkning er fint, men ikke kontinuerlig nedsænkning (se nedenfor for mere).
Nogle brands har forsøgt at opfinde deres egne definitioner af vandtætning. Men faktisk findes der en international standard - så Aquapac bruger naturligvis den.
The international standard is called IEC 60529 – Degrees of Protection Provided by Enclosures and it was developed by a technical committee of the International Electrotechnical Commission. In the USA it has been adopted by the National Electrical Manufacturers Association (NEMA) as an American National Standard.
IPX6 vandtæthedsniveau - du kan se resumé oversigt af IPX skala her https://aquapac.net/store/waterproof/
Hvilken størrelse har jeg brug for?
Etui fungerer sammen med de fleste insulininfusionspumper. Dette er den maksimale størrelse på enheden, der passer til:
Bælt strop
Bælte strop på bagsiden af etui (du kan sætte den i dit eget bælte - eller det medfølgende bælte)
Kan du svømme med det?
Vores test viser, at ”TC klemmen” vil lade en lille mængde vand ind efter en periode med total nedsænkning. Så det bedste råd, vi kan give, er at bære det på ryggen, hvis du svømmer brystsvømning og på din mave, hvis du svømmer på ryggen, så det bruger så lidt tid som muligt i direkte vandkontakt. Vi taler her om at plaske rundt i poolen eller havet, men vi taler ikke om udholdenheds- / langdistance svømning.
Farve
Materialer
Vægt
Oprindelsesland
Important Note regarding Insulin Pumps and Aquapac cases
Aquapac commissioned research by Imperial College London into the suitability of their cases for use with insulin pumps. Results show that in some circumstances insulin flow rate can be reduced by the case. In particular, low flow rates are impeded and as such Aquapac can make no claim regarding the suitability of these cases with insulin pumps. Use of these cases with insulin pumps is entirely at the discretion of the user.
We are advised to recommend that users of Aquapac cases with insulin pumps regularly check their blood sugar levels. Furthermore we strongly recommend that you get the green light from your consultant before use.
The tests were conducted by Imperial College of Science, Technology and Medicine using a Roche Accu-Check Spirit insulin pump at a temperature of 20C at flow rates of 2U/hr and 10U/hr. The amounts of insulin delivered over 60 minutes observed were as follows:
2U/hr not in a case – 0.0131g (flow rate of 100%)
2U/hr in Aquapac 150 – 0.0106g (flow rate of 81%)
2U/hr in Aquapac 150 – 0.0056g (2nd test model)(flow rate of 42%)
2U/hr in Aquapac 550 – 0.0121g (flow rate 92%)
10U/hr not in case – 0.0864g (flow rate of 100%)
10U/hr in Aquapac 150 – 0.0878g (flow rate of 100%)
10U/hr in Aquapac 550 – 0.0903g (flow rate of 100%)
21st August 2006
Special Instructions for the ‘TC’ Clamp
To open
To Close
Important Notes
Cases with this clamp are for surface use only, but will offer protection from temporary submersion. They are not recommended for prolonged immersion.
When not using the case leave the TC clamp open. If not the wire or tube could eventually cause a permanent distortion of the foam, risking leakage.
As long as you follow this instruction the clamp will be watertight with or without a wire/tube.
The maximum thickness of wire/tube around which the TC clamp will seal is 1/10th inch (2.5mm).